The Effect of Steel Plate on the Deflection of Self Reinforced Concrete Beam with and Without Opening

https://doi.org/10.24237/djes.2013.06104

Authors

  • Ali Sabah AL-Amili Engineering Collage, Al- Mustansirya University

Abstract

In this work aims at studying the influence of steel plate on the deflection of self- compacted reinforced concrete beams was investigated experimentally in this study to know the flexural behavior of these beams. Eight simply supported reinforced concrete beam were tested under the action of two point loads .The deflections of the beams with and without plate are measured. The steel plates of thickness (3 mm) with dimensions ( 170 × 350 mm) were used. These plates were sticked on the concrete beams using epoxy. The steel plate inside the beam was sticked with and without epoxy (epoxy type EP), while the beams were taken with and without opening (10 mm diameter). The results show that the plate increased the capacity of the beam by increased the value of failure load. Hence, the beam with internal plate with epoxy increased the failure load by 34.2% than beam without plate , and 24.6% than beam with internal plate without epoxy , and 19.7% than beam with external plate with epoxy .

Downloads

Download data is not yet available.

References

An, W., Saadatmanesh, H., and Ehsani, M. R.,"R/C beams strengthened with FRP plate. II: Analysis and parametric study." J. Struct. Eng., ASCE, (1991),pp. 111-117. DOI: https://doi.org/10.1061/(ASCE)0733-9445(1991)117:11(3434)

Dussek, I. J.. "Strengthening of bridge beams and similar structures by means of epoxy-resin-bonded external reinforcement." Transport. Res. Rec. 785, Transportation Research Board, (1980),pp. 21-24.

Mansur, M. A. "Design of Reinforced Concrete Beams with Web Openings" proceedings of the 6th Asia pacific structural engineering and construction conference (APSEC2006),Kuala Lumpur, Malaysia. September 2006,pp. 5-6

EFNARC, Specification and Guidelines for Self-Compacting Concrete. London, UK: Association House, February 2002, pp.32-34.

P. Kumar, " Self- Compacting Concrete: Methods of Testing and Design" Journal of Advanced Concrete Technology, Vol.86,February 2006 ,pp.145-149.

Hajime O. Kamura and Masahiro Ouchi, " Self- Compacting Concrete" Journal of Advanced Concrete Technology, Vol.1,No.1 ,April 2003, pp.5-15. DOI: https://doi.org/10.3151/jact.1.5

Jacob ,Hansen and Tomny Baek, " Self- Compacting Concrete Based on White Portland Cement" Concrete Plant International World Wide, February 2006, pp.84-93.

Nabil F. Grace and Wael F. Ragheb and George Abdel Sayed, "Flexural and Shear Strengthening of Concrete Beams Using New Triaxially Braided Ductile Fabric" ACI Structural Journal, Vol.(100),No.(6), November 2003,pp.804-815. DOI: https://doi.org/10.14359/12847

Angelo D. Ambrisi and Filip C. Filippou, "Modeling of Cyclic Shear Behavior in Reinforced Concrete Members", Journal of Structural Engineering, Vol.(125), No.(10), October 1999, pp.1143-1150. DOI: https://doi.org/10.1061/(ASCE)0733-9445(1999)125:10(1143)

ACI Committee 318 " Building Code Requirements for Structural Concrete (ACI 318- M08) ", American Concrete Institute, Detroit, USA, 2008.

Published

2013-03-01

How to Cite

[1]
Ali Sabah AL-Amili, “The Effect of Steel Plate on the Deflection of Self Reinforced Concrete Beam with and Without Opening”, DJES, vol. 6, no. 1, pp. 36–49, Mar. 2013.